Canon Mg2550 Reset !!top!! 💯 Proven

Canon PIXMA MG2550 Service Mode & Reset Instructions Important Notes:

Resetting the ink absorber counter is intended only after physically cleaning or replacing the absorber pads . This procedure resets the waste ink counter; ignoring physical overflow may cause ink leakage and permanent printer damage. Perform at your own risk – this voids warranty if applicable.

Steps to Enter Service Mode (Canon MG2550):

Power off the printer. Disconnect USB cable if connected. Hold down the Stop/Reset button (circle with triangle). While holding Stop/Reset , press and hold the Power button. Keep holding Power , then release Stop/Reset . While still holding Power , press Stop/Reset twice (some models: 5 times – see note below). Release Power button. The green power light will flash, then remain steady – Service Mode active. canon mg2550 reset

Reset Waste Ink Counter:

Download and run a compatible version of Service Tool (e.g., V3400, V3600, or V4700 for MG2500 series). Select USB port (ensure printer detected). Click “Main” (for pad counter) and “Platen” if both are full. Click “Set” or “Reset” . Printer may click/move – wait 30 seconds. Power off printer normally. Power on – error should clear.

Alternative Button Sequence (if above fails): Canon PIXMA MG2550 Service Mode & Reset Instructions

With printer off, hold Stop/Reset → press Power once → release Stop/Reset → press Stop/Reset 5 times → release Power .

If 5B00 or 5B01 Error Persists:

Repeat service mode entry carefully – timing is critical. Try a different Service Tool version. Manually clean absorber foam or replace with lint-free cloth/kit. Steps to Enter Service Mode (Canon MG2550): Power

This text avoids fluff and provides actionable steps for technician-level users.

Resetting a Canon MG2550 is a common necessity when dealing with ink level errors, "Ink Absorber Full" warnings, or general connectivity glitches. Because this model lacks an LCD screen, resets are performed through specific button sequences or "Service Mode." Quick Fix: Bypassing Ink Level Errors If you have refilled your cartridges or installed third-party ink, the printer may display a low-ink error (such as Support Code 1688 ) and refuse to print. The 10-Second Hold : Press and hold the Stop/Reset button (the red upside-down triangle) for approximately 5 to 10 seconds . The Result : This disables the ink counter for that specific cartridge, allowing the printer to continue. You may need to repeat this for both the color and black cartridges. The "Hard Reset" (Factory Reset) Use this method to restore original factory settings and clear general hardware hangs. How to Reset Canon Printer? | Printer Tales